Dometic PERFECTCHARGE MCA 1250, 12 V, 50 A, IU0U Battery Charger
- Item-No.: 420-00080
Dometic PERFECTCHARGE MCA 1250, 12 V, 50 A, IU0U Battery Charger
The simultaneous charging of up to three board batteries!
With its three battery outlets the Dometic PERFECTCHARGE MCA 1250 can charge upt to three 12V board batteries at the same time. And with input voltages from 110 V to 230 V it can be used anywhere in the world and continues to charge even when the input voltage drops. In addition, with the integrated multi-level charging technology, this device provides your batteries very gently. In sleep mode, the device provides noiseless charging at half power, making it ideal for the night or on electrically poorly secured parking spaces.
Possible damage to the device or the batteries prevents the integrated protection in case of short circuit, overvoltage or overheating. In its compact and lightweight design, it is easy to assemble and can be smoothly integrated into existing CAN bus systems via an existing interface. In addition, it is compatible with the optional Dometic MPC 01 battery controller, so you can manage the power perfectly.
In addition to the optional device extension with the MPC 01 battery controller, the device can also be extended with a remote control, a temperature sensor or the battery sensor from HELLA if required.
| Nennspannung Volt: | 12 Volt |
| Ladegeräte & Wechselrichter: | Batterie-Ladegerät |
| Ladeleistung Ampere: | 50 A |
| General technical informations |
|
| Battery types: | Lead-acid, gel, AGM & Li-Ion |
| Heat disipation: | With fan |
| Charge mode: | 5-level |
| Maximale ambient temperature: | -20 ˚C to +50 ˚C |
| Storage temperature: | -40 ˚C to +85 ˚C |
| Air humidity: | 20 to 90 % |
| Temperature coefficient: | ± 0,03 % / ˚C (0 to 50 ˚C ) |
| Temperature compensation: | -20 mV/ ˚C (battery sensor) |
| Vibration: | 10 to 500 Hz 2 g for 10 min/cycle within 60 minutes for X-, Y- and |
| Voltage insulation: | I/P-O/P: 4 kV~ I/P-FG: 1,7 kV~ O/P-FG: 0,7 kV~ |
| Insulation resistance: | I/P-O/P: 100 MΩ/500 V |
| Alarm signal: | Via relay contact |
| Communication: | Via LIN-BUS |
| Sleep mode (noise-reduced mode): | Via remote control (optional accessory) or DIP-switch |
| Remote control (optional accessory): | On/Off switch, three-colour LED, sleep mode option |
| Measurement: | 238 x 179 x 63 mm (Length x Width x Hight) |
| Weight: | 3.1 kg (6.8 lbs) |
| Dometic Item-Number: | 9600000031 |
| EAN-Number: | 4015704250350 |
| Protective devices |
|
| Output side short circuit: | Current is reduced to 25 % of the maximum current |
| Overvoltage: | 16 V |
| Battery charger over temperature: | 100 ˚C ± 5 ˚C (measured internally) |
| Battery over temperature: | 52 ˚C ± 5 ˚C (with battery sensor) |
| Input data |
|
| Rated input voltage: | 90 to 260 V~ |
| Output factor correction: | > 97 % (full load) |
| Input frequency: | 50 Hz to 60 Hz |
| Efficiency at 230 V~: | 87 % |
| Leakage current: | < 1 mA at 240 V~ |
| Input current at 100 V~: | 8,24 A |
| Input current at 240 V~: | 3,6 A |
| Output data |
|
| Charging voltage: | 14,4 V / 14,7 V |
| Retention voltage: | 13,8 V |
| Rated charging current: | 50 A |
| Charging current: | 0 to 50 A |
| Number of outputs: | 3 |
| Number of ESB-outputs (Starter battery) | 0 |
| ESB-charging voltage: | n/a |
| ESB-charging current: | n/a |
In the delivery are included
- the battery charger
- a 230-V connecting cable, and
- a multi-lingual installation and operating manual
Other accessories, like mounting material or similar, is not part of the delivery!
