Keep a reliable overview of the charge status of your starter and / or on-board battery!
With the easy-to-use control panel you always have full control over your starter and / or board batteries. With the PerfectCharge MPC 01 battery management system from Dometic, you can monitor and analyze additonally to your starter batterie up to three further board batteries with appropriate sensors.
Thus, all common battery parameters like supply, voltage, temperature, rest loading time and capacity (in %) are available and you will be warned, should an energy shortage occur or a battery has been damaged. Thanks to the CIS BUS interface, the MPC 01 can be perfectly integrated into complex power systems.
However, the MPC 01 control panel may only be operated with Dometic PerfectCharge MCA chargers!
|Zubehör Energie & Steuerung:||Batterie-Management|
130 x 115 x 6 mm (Width x Height x Depth)
Installation frame dimensions:
150 x 136 x 16 mm (Width x Height x Depth)
8 - 30 Volt
150 mA in display mode,
Included in the delivery are:
- 1x adapter board and cover
- 1x cover frame
- 1x display
- 1x assembly frame
- 1x battery sensor (MCA-HS1 Hella sensor)
- 1x battery sensor connection cable
- 1x charging unit connection cable
- 1x control cable
- 1x control cable connected mass (black)
- 1x control cable positive pole (red)
- 4x screws, long
- 4x screws, short, and
- a multi-lingual assemply and operating instruction
When operating more than one battery, you need additional battery sensors! These can be found here.
MPC01 enables the charge status of the starter battery and up to three supply batteries to be monitored. To do so, the battery sensors are connected to the negative pole of the batteries. The information read out from them is transmitted to the display via the CI bus interface. The battery sensors measure the voltage, current and temperature of the connected battery.
Along with the battery sensor supplied, up to three more battery sensors (optional accessory; see scope of delivery) can be connected.
MPC01 features three programmable outputs for switching off consumers should the battery capacity be too low (battery monitor function).
The battery charger is connected to the display via the CI bus interface.
MPC01 features a display mode, and a stand-by mode which is activated after a preset interval.
A programmable alarm function reminds the user of the preset time.
A jumper allows the operating mode to be changed from “caravan” to “boat”.