Dometic FlyTec FT200 flyscreen for sliding doors, left hand drive vehicles
Being close to nature has one drawback: insects in your mobile living room and bedroom can be a real nuisance. Which makes it best to take simple precautions and add a custom-fitted fly screen to the entrance. The fly screen covers the entrance completely and has a magnetic closure.
This one is for the higher version (min. 1298 mm x 1765 mm = Width x Hight) of sliding doors featured by vehicles such as Fiat Ducato H2 X250 / X290 or their similar "brothers" Peugeot Boxer and Citroen Jumper, all since construction version July 2006 or younger.
Before you decide to order this insect screen, please check in advance on your vehicle whether the requirements for a successful installation can be met. The above picture # 4 and important information in the opposite tab "Good to know!" offer a good orientation.
If all the requirements are met, the actual assembly is relatively easy. And from this moment on you keep flies, mosquitoes and other animals out of the inside of your vehicle when closed.
Scope of delivery:
- 1x Skirting board
- 1x Cassette profile with flyscreen & guide cables
- 1x C pillar cover
- 7x Blind rivet (4 x 8 mm with stainless steel mandrel)
- 1x Fastening screw M5 x 30 mm and M5 nut
- 1x Guide rail above
- 1x Safety clip and screw M2, 5 x 6
- 1x Deflection screw M4 with safety clip and screw M2, 5 x 6, and
- a multi-lingual installation and operating manual
The screws for fastening on the vehicle are not included in the scope of delivery.
Please note that there are also low-roof versions of the Fiat Ducato, Peugeot Boxer and Citroen Jumper with a sliding door dimension of "only" 1128 x 1492 mm (width x height). The insect screen door offered here is too small for this dimension and cannot be adjusted accordingly (for example shortened in height).
The installation opening must not be reduced by built-on strips, covers, fixtures or the like. This should be at least 1298 x 1765 mm (width x height). See also picture # 4 above (diagram labeled "X" and "Y").
There must be a clearance of at least 40 mm between the rear, vertical sliding door seal and any built-in furniture so that the insect screen can be installed. See picture # 4 above (detailed diagram, small circle).
A free space of 18 mm must be available between the outer edge of the body floor and any built-in cupboards (e.g. a kitchen block). See picture # 4 above (detailed diagram, large circle).
The insect screen must be screwed to the body panel at the top. A screw connection on the cladding or the interior will not hold up sufficiently! On the other hand, a lower screw connection to the interior fitting floor is normally unproblematic.
In principle, in all areas in which screw connections are made, it is essential to check beforehand that there are no cables, lines and / or other components, especially those that are not visible.