1x ALCAR 6011 original steel wheel for Fiat Ducato, 16 inch, Light chassis1 peace original Alcar steel wheel in the size 6J x 16 H2 (5x118x71.1), rim offset 68, for Fiat Ducato with Light-Chassis.The load capacity per rim is 1,100 kg (i.e. 2,200 kg per axle with two tires). A corresponding certificate / GOP (GOP = general operating permit) is enclosed with the delivery for your vehicle documents. Further technical details on the rim can be found in the information tab below.Important Information! These steel wheel is NOT suitable for the "Maxi-(Heavy-)Chassis" version delivered by FIAT since 1994, because its 16-inch-steel wheels have a bolt circle of 130 mm and a center hole of 78.1 mm.
Fiat has been offering this wheel cover model since March 2014 and will normally fit on all 16 inch steel wheels with a flat inner rim flange.If you are not sure whether your steel rims have such a flat rim flange, you can easily check this yourself. For example, place a smaller spirit level on the flange ring so that one end of the level projects beyond the outer edge of the rim. Now measure the distance between the edge of the rim and the lower edge of the spirit level. If this distance is significantly more than 17 mm, then this wheel cover will unfortunately not fit on your steel rim. The wheel cover would be too much "bent" by the too far projecting rim flange, so that they can not cling firmly.The here offered wheel covers / decorative caps were part of a new car delivery. These were never assembled. Before sale, all wheel covers are checked for visible defects (eg due to previously improper storage and / or transport). They are basically new and in perfect condition!The wheel covers are made of plastic, color silver, and will be attached with clamping rings (part of the delivery) to the steel wheels.
4x original ALCAR 6011 steel wheel for Fiat Ducato, 16 inch, Light chassis4 peaces (= 1 set) original Alcar steel wheels in the size 6J x 16 H2 (5x118x71.1), rim offset 68, for Fiat Ducato with Light-Chassis.The load capacity per rim is 1,100 kg (i.e. 2,200 kg per axle with two tires). A corresponding certificate / GOP (GOP = general operating permit) is enclosed with the delivery for your vehicle documents. Further technical details on the rims can be found in the information tab below.Important Information! These steel wheels are NOT suitable for the "Maxi-(Heavy-)Chassis" version delivered by FIAT since 1994, because its 16-inch-steel wheels have a bolt circle of 130 mm and a center hole of 78.1 mm.
The here offered suspension strut, front left, for a Fiat Ducato X250 / X290 with heavy chassis from year of construction June 2006 is an original part. This also fits to the identical models Peugeot Boxer and Citroen Jumper.This absorber strut comes from a new Fiat Ducato van, which has been converted on customer specification from the standard gas- to air-absorbation. The mileage of the new vehicle was at the time of conversion less than 20 km, so this suspension strut is considered to be almost new. The expansion was done expertly.Spring color labeling: White - Purple - Yellow - Yellow
The here offered suspension strut, front right, for a Fiat Ducato X250 / X290 with heavy chassis from year of construction June 2006 is an original part. This also fits to the identical models Peugeot Boxer and Citroen Jumper.This absorber strut comes from a new Fiat Ducato van, which has been converted on customer specification from the standard gas- to air-absorbation. The mileage of the new vehicle was at the time of conversion less than 20 km, so this suspension strut is considered to be almost new. The expansion was done expertly.Spring color labeling: White - Purple - Yellow - Yellow