€477.00*
Available in 3 days, delivery time 2-6 days
The digital parking aid MWE 7106F with PPS (Parameter Programming System) from Dometic for the front of a car or van.
Contrary to the similar parking aid MWE 7006 in three stages, the sensitivity of the sensors (Ø 18 mm) of the MWE 7106F can be individually adjusted according to your own needs. The parameter programming system also enables the detection area and the actual stop zone to be set individually.
The six ultrasonic sensors included in the scope of delivery can be mounted on your vehicle in three different ways. Depending on the type of your vehicle, this parking aid not only protects the lower half of the front of the vehicle, but also extends it to the upper half and the sides, for example.
With its three mounting variants, this system is ideal for high and wide cars, vans or mobile homes. It acoustically and visually monitors the front area at a distance of approx. 0.35 to 1.20 meters and automatically mutes the radio when maneuvering and offers almost the same parking comfort as an original factory-installed system.
In order to avoid annoying beeping under certain circumstances due to insufficient distances in city traffic or in traffic jams, the front parking aid can be switched off and on again if necessary using an optional switch. You can find more details on this in the adjacent information tab "Good to know!".
Supply voltage: | 10 - 24 V |
Power consumption: | maximum 350 mA |
Ultrasonic frequency: | 58 kHz |
Operating temperature: | -25 °C bis +70 °C |
Measuring range: | ca. 0.6 m up to 3.0 m |
Radio mute: | YES |
Parameter programming (PPS): | YES |
Warning function: | Acoustically |
Activation by: | - Speed signal - ON/OFF switch (optional = see accessories) |
Number of sensors: | 6 pieces* |
Cutout of the sensors: | 18 mm |
Visible sensor area: | 18 mm |
In the delivery are included:
- 1x Control electronics
- 1x Loudspeaker
- 1x Control electronics connection cable
- 1x Sensor distributor
- 6x Ultrasonic sensors with connection cable
- 6x 0 degree sensor holder with cover ring
- 6x 10 degree sensor holder with cover ring
- Fastening material, and
- a multi-lingual installation and operation manual
Other accessories, such as other sensor holders (for sub-mounting or surface mounting), extension cable or LED display, are not included in the scope of delivery.
To integrate the system into digital vehicle technology, an additional CAN bus interface (conversion of the analog signals from the control electronics into digital signals) may be required. The Dometic CBI 200 CAN bus interface supports a variety of these vehicles. We will be happy to provide the current Dometic type list upon request. However, under certain circumstances, a vehicle-specific adapter may have to be used, which must be obtained from independent retailers. If you are unsure about this, please contact your trusted car workshop.
The sensors can and may be painted.
And please always remember that a parking aid should provide you with additional support. However, this does not mean that the use of this device (as well as all other auxiliary systems) does not release you from fulfilling your special duty of care and caution when manoeuvring.
Login